Activity Stream

I did a whole week all day everyday of a carbine course, and not been bothered with my B&T flow RH 5.56 SC. I cannot do more than several rounds in...

A flow-through will help, but as a lefty, you're still going to get gas out of the ejection port. How much and will it matter? I don't know, that...

I just ordered the RMR HD, I chose the 1 MOA model. I am either going to put this on 11.5 as an offset or replace the RCR on my Prodigy with it and...

So after more fence sitting and a whole lot of deliberation, I have decided finally to wave the white flag of surrender. This week I am going to hit...

I was finally able to run my 6390 with the HD the other day. It seems like it sits higher (mid-ride config). But that might just because of how...

Glock 47 picked up and RMR HD mounted. Amazingly, it was perfectly zeroed without touching it. I need to figure out if I want to put optic height...

It's a RSA sling attach point. Initially that was where I was putting the sling, but when I had to make room for the LAM and switch, it wasn't an...

Nice. What's in that first slot on the handguard, near the upper?

I did give Riflespeed a thought of purchasing, but my Mk14 handguard is too small an inside diameter and it's 10.5 length with an 11.5 barrel doesn't...

I have seriously thought about going to the Ruger 204. Wish I could trade barrels with someone. Thanks for the responses

The Griffin SNACH might be a bit better, but I really can't imagine a CH is going to materially improve anything that overgassed. I know my Sig...

LMT tube was installed, problem solved. Went to test the Griffon BCG out now that I had a TDP in spec tube, and I did not notice a major change but...