Activity Stream

Hope all goes well i feel your pain , I have 7 sublexed discs from a work injury that I got royally fucked on by lni. I also tore something in my...

Wish I could go. Instead I get to have my L4 and L5 vertebrae chopped, shaved, spaced correctly and bolted. Supposed to be back in fighting shape...

I call dibs on any 416 or SR 16 uppers ya find rolling around in the junk drawer!

Damn, it's been a minute since I've seen a Black Hole Weaponry, Rainier Arms Select barrel... Let me look in the bin and see if I have a 9.5 floating...

Let me know if you're going to make it out on Saturday. I'm going to be there Friday, but will likely be there for the last half of Saturday so I can...

I'll be their limping around range day & Fri

With the SOLGW Nox you can get a 13.7 barrel out to 16” and use the dead air can. That’s only a functional 1.2” longer than the 12.5 and a savings of...

It may have been D4. I know he was singing its praises at a class I was at (after I had already discovered the length myself). He was actually...

12.5" is a great length. I have 2 Noveske Crusader 12.5" builds and they are handy and function reliably. Many years ago I did a ton of research on...

Another pic minus tube, pin etc

I hear ya joelski...this whole build has been a little off The dumb spikes st-2 buffer is a H2 in sense. 4.3oz vs 4.6oz of a true H2. It’s...

That looks off by 3/16" at least!! :eek:

You don't want that old piece of shit. box it up and send it to me.

few Pics of the buffer pin area

Well It’s for this old 10.5” RA barrel...So id like a 9.5-10”

Sounds like an out of spec receiver set. The bottom is doing what it's doing and the upper is combining a tightass fit with slamfucking the buffer...

What length handguard do you need?

Can you take a picture of the lower like this: One picture with the buffer itself installed and one with it removed And if TWO BCGs...

Thanks for reminding me....I’ve seen These..just had forgot who made them It probably lay got lost in my verbiage...lol Parts list is/was ...

Who makes the lower? The retaining pin channel looks like it’s milled pretty far forward As far as the upper (same brand as lower?) I’ll take a...

Check this out: https://gallowayprecision.com/ar-15/offset-buffer-retainer-for-AR-15-rifles/

I shot a 10.3" Colt M4-profile barrel (cut from a 16") out to 500y with my Elcan on a near-zero wind day and was getting very reliable hits once I...

Sorry..Damn auto correct....Title= upper reliever...lol Back to topic... should I find another upper? Along with the lower/buffer issue? The...

Goose egg.. Would like to do one 556 and a 9 mil setup eventually

Thinking hard about going....it always lands on the woman’s b-day weekend... Might talk her into it....would be Saturday most likely if so. ...

I probably should have mentioned that , I only run 30 cal cans

The website shows all 3 of his 11.5” barrels are cut for 5/8x24 threads....that’s a no go for me

Noveske 12.5 Crusader Barrel. Best 12.5 on the market.