Mega
10 December 2009, 18:06
I recently bought a pair of Magpul B.A.D (Battery Assist Device) levers and had the opportunity to install them today.
The first one went on my Bushmaster CQB carbine.
Install took only minutes and after a function check, I declared it good. [:)]
The next one was installed on my SPR (M&P15 lower and LaRue 'Stealth' upper). Install went smoothly, but after a function check, it appears that the backing plate on the bolt catch was interfering with the LaRue upper housing. :(
Apparently, LaRue puts a little more 'meat' in their uppers and the tolerences are tighter than they were in my Bushie.
Anyone else had a problem installing a Magpul B.A.D on their weapons?
The first one went on my Bushmaster CQB carbine.
Install took only minutes and after a function check, I declared it good. [:)]
The next one was installed on my SPR (M&P15 lower and LaRue 'Stealth' upper). Install went smoothly, but after a function check, it appears that the backing plate on the bolt catch was interfering with the LaRue upper housing. :(
Apparently, LaRue puts a little more 'meat' in their uppers and the tolerences are tighter than they were in my Bushie.
Anyone else had a problem installing a Magpul B.A.D on their weapons?