XTM panels on Noveske rail

[C_F]

I was wondering if the magpul XTM panels will fit over the sling QD hole in the middle of Noveske rails? :confused:

C_F

[Stickman]

Here you go....

http://stickman.rainierarms.com/galleries/Magpul%204/STCK0448-1024-Stick.jpg


http://stickman.rainierarms.com/galleries/Magpul%204/STCK0449-1024-Stick.jpg

[C_F]

Thanks, I didn't know if they engaged down into each slot in the rail or not, and I have the 9" rail with the sling adapters right in the middle of it.

[TehLlama]

It takes some dremel work to work around those - though running a hollowed out rail ladder over those allows the QD adapters to remain usable while covering the rail. Rails like the SWS and TROY MRF are one of the few cases where XT's and the TangoDown covers can have an edge over XTMs.

[T Man 360 Fan]

Stick man, is there a qd hole under those xtm's? Also do you have to skip the 1st rail space or modify them to use em?