PDA

View Full Version : PRI or Other type forearms/ rails for this build?



Rather_Static
2 February 2008, 13:01
Gents,

I have a 20" BBL, flat top upper, armalite rifle length rail, BUIS's, stock, everything I need except a ff rail or tube setup.

I am not going to make an exact copy of any SPR MOD or similar..I just want to use the rail to join the two sections together, and mount the scope and BUIS (front and rear) on...I already have a cut down and dremmeled FSB for the block..

Is the PRI the way to go or will I need the ARMS rail or PRI's rail? If there are other options, what would you suggest?

TIA.

R_S

Paulo_Santos
2 February 2008, 15:49
I like the Troy or MI rails because they are affordable and have the monolithic rail look. The DD Lite Rails are probably the best, but very expensive.

crowdlg
17 April 2008, 15:27
I have a pri on my mod-0 with the swan.A pri rail can be used without it but I also have troy rails in 10 inch and 13.5 in and think i would recommend them first due to they seem a lot more rigid and I percive as stronger than the cabonfiber pri.