PDA

View Full Version : OCP SLING MOUNT-N-SLOT by Impact Weapons Components



MOUNT-N-SLOT
28 October 2010, 17:43
If you have a MOE or any ROUND, Tubular hand guard or foreend like a TROY TRX/VTAC Extreme, JPI/VTAC, YHM, PRI, Midwest Industries, etc...

IWC will have our NEW OCP MOUNT-N-SLOT available this weekend. The OCP (Oblique Connection Point) is similar to IWC's Snap Hook MOUNT-N-SLOT, but mounts on an angle directly to the hand guard/foreend using a single attaching screw, and increases the access to the loop, allowing faster hook in and more comfort for the operator's support hand.

We'll start a thread for this and our other NEW PRODUCTS here on WEVO and our other Forums, as well as our site and official fan page on facebook.

We also plan of sending one to Quib for a review.


Thanks!

MOUNT-N-SLOT

MOUNT-N-SLOT
31 October 2010, 22:35
Here's a pic of IWC's new OCP MOUNT-N-SLOT designed to attach directly to any Round, Tubular hand guard / fore end with slots and / or holes, like: TROY TRX/VTAC Extreme, JPI/VTAC Fore Ends, etc., as well as for ANY Magpul MOE Hand Guard.

The Oblique angled design increases operator comfort and control on the narrow end, while increasing the height of the loop off the hand guard for rapid and improved sling attachment. This OCP MOUNT-N-SLOT was specifically designed to act as the connection point between the weapon and Magpul's MS2 & MS3 sling attaching devices.

Our PATENT PENDING design will be available to order / ship on IWC's site this week.

http://i998.photobucket.com/albums/af110/mount-n-slot/OCP%20MOUNT%20N%20SLOT%20Sling%20Mount/VTAC-2.jpg

Thanks,

MOUNT-N-SLOT

NickDrak
31 October 2010, 22:52
I F***in" love it! I will be standing-by to place my order for one of these and one of the hand-stops....

HeavyDuty
21 November 2010, 12:16
A couple more pics, this time on a TRX-E...

http://i892.photobucket.com/albums/ac123/HDF62/MNS-TRXE-OCP-1.jpg
http://i892.photobucket.com/albums/ac123/HDF62/MNS-TRXE-OCP-2.jpg

BravoHotel
1 February 2011, 11:34
Any chance of seeing the back mounting bolt piece? Looking to modify one of my round free-float handguards by drilling a hole in it and using one of these. Just trying to confirm if it would work or not before dropping the coin.

Thanks.