PDA

View Full Version : Geiselle Automatics install question



parabellum
8 February 2008, 15:04
I'm going to be installing a GA trigger on a POF 415 billet lower.

I have a set of KNS anti spin pins. Should I use GA's trigger and hammer pins, or should I use KNS pins?

[noob]


thanks.

John Hwang
8 February 2008, 15:52
I've used the KNS pins without issue they will work fine with the GA trigger. If your receiver is used, make sure to get the .155. Otherwise, get the .154 for new receivers. However, I recommend sticking with the pins they provide as they are a little oversized and polished.

parabellum
8 February 2008, 16:08
I've used the KNS pins without issue they will work fine with the GA trigger. If your receiver is used, make sure to get the .155. Otherwise, get the .154 for new receivers. However, I recommend sticking with the pins they provide as they are a little oversized and polished.


the lower is still stripped, I'm pretty sure I have the "small" pins. Thanks a lot!!!