StrykeBack
29 September 2013, 01:59
I'm seeing directions for my 15" NSR rail that the screws should be installed with a torque screwdriver to 30 inch pounds?
I've never even heard of a torque screwdriver before this. If you had access to an inch pounds torque wrench is there a tool that could make that work? Most torque screwdrivers I'm seeing online are listing around 200 bucks!
Or should I make these all hand tight with thread locker along the same lines as the guys that say just use a crescent wrench rather then a torque wrench for the barrel nut?
I've never even heard of a torque screwdriver before this. If you had access to an inch pounds torque wrench is there a tool that could make that work? Most torque screwdrivers I'm seeing online are listing around 200 bucks!
Or should I make these all hand tight with thread locker along the same lines as the guys that say just use a crescent wrench rather then a torque wrench for the barrel nut?