View Full Version : Flash Suppressor installation?
jvencius
1 August 2008, 08:53
Do you need to use any moly grease or antiseize compound when installing a flash suppressor on an AR (or on any other firearm, for that matter)?
TigerStripe
1 August 2008, 09:13
No, just the FS and a crush (or peel) washer if the FS requires a washer.
TS
jvencius
1 August 2008, 09:16
Cool--thanks. I had a Smith Vortex waiting in my toolbox for when I got the upper back from Sabre so I'll snug it down (but not too much--5 lb/ft really isn't a lot) and call it good.
TigerStripe
1 August 2008, 11:04
Cool--thanks. I had a Smith Vortex waiting in my toolbox for when I got the upper back from Sabre so I'll snug it down (but not too much--5 lb/ft really isn't a lot) and call it good.
It should be GTG.
TS
Stickman
1 August 2008, 14:03
Cool--thanks. I had a Smith Vortex waiting in my toolbox for when I got the upper back from Sabre so I'll snug it down (but not too much--5 lb/ft really isn't a lot) and call it good.
Remember that no washer is used when installing the Vortex FS.
jvencius
1 August 2008, 14:36
Remember that no washer is used when installing the Vortex FS.
Yep--I didn't use one.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.