A new tool Mod that I came up with...

[edn9ht]

I am a beginner with the AR15 and just thought I would share an idea I came up with to help me with the bolt catch roll pin...
I have not seen anything like this on the market so I made my own tool...
I think it's handy, maybe someone else will too.

Link to video of me using it:
https://www.youtube.com/watch?v=2fYCEzg0jno

Link to me modifying the tool:
Part 1
https://www.youtube.com/watch?v=owHk55KMLB4

Part 2
https://www.youtube.com/watch?v=-M_bCvDBNnk


Thanks!
Ed.

[Ride4frnt]

That, sir, is not a bad idea! +1 internets for you!

[WHSmithIV]

I put mine in using vice grips with the jaws taped with electrical tape. Worked just as if it was a press :)

[DutyUse]

I put mine in using vice grips with the jaws taped with electrical tape. Worked just as if it was a press :)

I did mine the same way with good success

[edn9ht]

Yes I think a lot of people do it that way... This was just a thought I had one day and wanted to see if I could do it cheap and with very basic tools.
I had a lot of fun with it. And it is a nice little addition on my gun bench.
Just thought I would share it...

Thanks!
Ed.