rxer311
28 April 2016, 17:59
So I got my Noveske Gen 1 lower yesterday and started to put it together tonight. It started off as a stripped "chainsaw" lower but the only blem I could find was inside the mag well. Any other marks on it were put on it by me as I was pounding the roll pin into the bolt catch. Anyway here is the direction I went with it...but this could change at any moment.
Noveske Chainsaw lower
Ruger 2 stage trigger
Noveske takedown and pivot pins
Strike Industries bolt catch
Strike Industries trigger guard
Strike Industries 7 position stock
Lanco Tactical QD endplate
Magpul MOE SL stock
B5 Pistol grip
Odin Works Gen 2 extended mag release
All other parts are standard mil spec
So now I have to figure out my upper receiver...
http://i112.photobucket.com/albums/n164/rxer311/IMG_1201_zpswsanlhc3.jpg (http://s112.photobucket.com/user/rxer311/media/IMG_1201_zpswsanlhc3.jpg.html)
http://i112.photobucket.com/albums/n164/rxer311/IMG_1200_zpsdxunaalm.jpg (http://s112.photobucket.com/user/rxer311/media/IMG_1200_zpsdxunaalm.jpg.html)
Noveske Chainsaw lower
Ruger 2 stage trigger
Noveske takedown and pivot pins
Strike Industries bolt catch
Strike Industries trigger guard
Strike Industries 7 position stock
Lanco Tactical QD endplate
Magpul MOE SL stock
B5 Pistol grip
Odin Works Gen 2 extended mag release
All other parts are standard mil spec
So now I have to figure out my upper receiver...
http://i112.photobucket.com/albums/n164/rxer311/IMG_1201_zpswsanlhc3.jpg (http://s112.photobucket.com/user/rxer311/media/IMG_1201_zpswsanlhc3.jpg.html)
http://i112.photobucket.com/albums/n164/rxer311/IMG_1200_zpsdxunaalm.jpg (http://s112.photobucket.com/user/rxer311/media/IMG_1200_zpsdxunaalm.jpg.html)