PDA

View Full Version : SMOS Part 2



rxer311
29 August 2016, 16:14
So this is almost complete. Just looking for glass to top it off. Probably going to go with a Vortex Strike Eagle 1-6. So here is my parts list:

SMOS GFY Receiver Builder's Pack (13.75" rail)

Lower Parts:
- BAD adjustable pistol grip.
- Mil spec 7075 receiver extension with H buffer (Titanium QD endplate)
- CMMG LPK (Odin Works V2 mag release and Strike Industries Chrome extended takedown pins)
- Ruger 2 stage FCG
- Magpul STR (may swap for an ACS)

Upper Parts:
- Strike industries Ejection port door
- BCM Medium Latch CH
- Toolcraft/Cryptic coatings Nitride BCG with c158 bolt
- Larue 16" PredatAR barrel
- SLR micro gas block
- Rainier Arms RMC v2 (waiting for it to arrive)

The last picture was just some of the lowers I picked up "just in case."

http://i112.photobucket.com/albums/n164/rxer311/IMG_1363_zpsnhaxewgc.jpg (http://s112.photobucket.com/user/rxer311/media/IMG_1363_zpsnhaxewgc.jpg.html)
http://i112.photobucket.com/albums/n164/rxer311/IMG_1362_zpsqw8lntez.jpg (http://s112.photobucket.com/user/rxer311/media/IMG_1362_zpsqw8lntez.jpg.html)
http://i112.photobucket.com/albums/n164/rxer311/IMG_1361_zpsa4yhzkyw.jpg (http://s112.photobucket.com/user/rxer311/media/IMG_1361_zpsa4yhzkyw.jpg.html)
http://i112.photobucket.com/albums/n164/rxer311/IMG_1364_zpsp0s8uxrc.jpg (http://s112.photobucket.com/user/rxer311/media/IMG_1364_zpsp0s8uxrc.jpg.html)

SINNER
29 August 2016, 16:28
Nice. Those barrels are shooters.

Pyzik
20 September 2016, 06:05
Lookin good so far