Results 1 to 5 of 5
  1. #1
    Join Date
    Jan 2009
    Posts
    863
    Downloads
    0
    Uploads
    0

    Trigger Guard, Forward Controls

    Trigger Guard, Forward Controls is now shipping in black, desert tan, and OD green. Available in either standard/straight, or winter versions :) Standard/straight version is in black only till 2020.

    Name:  tgf2.JPG
Views: 707
Size:  65.9 KB

    https://www.forwardcontrolsdesign.co...ols_p_178.html

    TGF (Trigger Guard, Forward Controls) is available in standard (straight) and winter versions. Both are machined from 7075 aluminum, they do not have spring loaded detent for the front, but use a set screw like Magpul's, and a standard trigger guard roll pin in the rear.

    Both versions feature a canted front edge to make rocking the magazine into the mag well easier. The winter version has as much constant/unchanged space from the trigger bow forward as possible (instead of of the space inside tapering and decreasing as the trigger guard nears the receiver's front trigger guard holes). The space to the rear of the trigger bow is inaccessible for the user's finger, so it's kept small and low. Available in anodized black, desert tan, and OD green (desert tan and OD green for standard/straight TGF in 2020).

    Name:  tgf3.JPG
Views: 544
Size:  76.2 KB

    TGF is designed for use with in spec forged lower receivers, and fills the gap forward of the pistol grip, between the trigger guard "ears" (note that TGF will not swing down like TDP spec trigger guards). All the sharp edges and corners have been removed. Due to the variations and tolerances of receivers, fitting might be required for receivers too far from TDP dimensions and tolerances.

    TGF includes a trigger guard roll pin and set screw (for the front). A 1/16 Allen wrench is required (not included).

  2. #2
    Join Date
    Sep 2016
    Location
    Fl
    Posts
    170
    Downloads
    2
    Uploads
    0
    They look great can't wait to get them!
    “Fast is fine, But accuracy is final.” Wyatt Earp

  3. #3
    Join Date
    Sep 2010
    Location
    PNW
    Posts
    15,286
    Downloads
    0
    Uploads
    0
    Looks great Roger! Just picked up a couple of RBFs from Rainier

  4. #4
    Join Date
    Jan 2009
    Posts
    863
    Downloads
    0
    Uploads
    0
    For Colt, LMT, and BCM receivers, and receivers made from Cerro Forge forgings, the trigger guard ears are almost flush with the bottom of the TGF.
    Name:  69914207_10215614882629835_4156171180107104256_o.jpg
Views: 389
Size:  104.9 KB

    For ZEV made receivers, there's protrusion of the trigger guard under the ears. ZEV made receivers appear to have shorter ears, but TGF lines up with the grip.

    Left: ZEV lower. Right: Colt lower.
    Name:  69835491_10215593979067259_2135623409344708608_o.jpg
Views: 365
Size:  65.3 KB

  5. #5
    Join Date
    Sep 2010
    Location
    PNW
    Posts
    15,286
    Downloads
    0
    Uploads
    0

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •