Radian Arms comp and barrel now available to fit Gen 4 and Gen 5

[FortTom]

Radian Arms has been making their has been making their After Burner and Ramjet barrel for Glock 19 gen 3 for a couple of years now. I've got one on my G19 for a while and can say that I've been more than happy with it. NOW the RADIAN arms company is making them for Gen 4 and Gen 5 as well as the Sig 365. It's a great barrel compensator kit that requires very little in the name of tools as it locks to the bottom of the specially made barrel via a single tapered lock screw, requires no timing, and is the perfect product for someone who can't use threaded barrels in their state, wants a self timing "micro" compensator, and no modifications to their firearm. Not to mention about a 15 minute installment time.

They lock and self time by using a tapered screw that fits in a grove cut into the bottom of the barrel. The comp is small and only takes a few minutes to install. They also make a kit for the Gen5 G17. The comp is only about .5 inches thick and required my G19 gen 3 to go up to a G17 holster, which it fits beautifully. The barrel is very accurate and the comp works perfectly. Check them out here, at Radian Arms. https://www.radianweapons.com/en/pis...rburner-ramjet I also recommend installing a tungsten guide rod for even less muzzle flip and recoil.

[MonkeyBomb]

I picked up the Ramjet afterburner last October for my G-45. I sighted it in and played around with it a bit last fall. This spring I managed to get some time behind that combo. I have to say, I really like it. I was shooting steel with the G-45 and an SS Mr920 (that is my favorite carry gun and gets a lot of range time). I'm way faster on steel plates and dueling stands with the G-45 and Ram Jet setup.

I have to say I'm pretty happy with the setup. I would love to do a side by side comparison with the Ramet setup and the SS MR920P.