Results 1 to 11 of 11
Thread: Midwest Industries Rails?
-
2 November 2009, 19:48 #1Member
- Join Date
- Jun 2009
- Posts
- 25
- Downloads
- 0
- Uploads
- 0
Midwest Industries Rails?
Are MI rails gtg? They are pretty cheap compared to other brands (troy, vtac, dd). I'm not ML or LE, but I only want to cry once, and don't want something that'll wiggle. I plan on mounting a red dot on it.
Specifically, I have an A2 rifle, and I don't want to replace the front sight. Is 12" the right size?
http://www.primaryarms.com/product.s...&categoryId=36 This is what I'm looking at right now.
-
2 November 2009, 20:14 #2
That will work if you have the Rifle Length gas right now. That one that you linked is their new 1-piece handguard, which is similar to the YHM handguards. They are very good for the money. Also check out the YHM Diamond series handguards.
-
3 November 2009, 06:16 #3Contributing Member
- Join Date
- Oct 2009
- Posts
- 237
- Downloads
- 0
- Uploads
- 0
Are they the same diameter as YHM rails? I have a YHM lightweight on a 9mm upper, and it feels kinda chubby to me. Or am I nuts - are most rails about the same diameter?
-
3 November 2009, 08:42 #4Member
- Join Date
- Jun 2009
- Posts
- 25
- Downloads
- 0
- Uploads
- 0
-
3 November 2009, 09:17 #5
-
3 November 2009, 09:51 #6
-
3 November 2009, 10:22 #7
-
4 November 2009, 06:15 #8
-
4 November 2009, 06:21 #9Contributing Member
- Join Date
- Oct 2009
- Posts
- 237
- Downloads
- 0
- Uploads
- 0
-
4 November 2009, 13:04 #10Member
- Join Date
- Jun 2009
- Posts
- 25
- Downloads
- 0
- Uploads
- 0
Hey guys, thanks for the help. I have a rifle length gas with a 17.5" barrel (cut from 20).
I found a used troy that I'm going with. It's about 5 ounces lighter than the MI SS I was looking at, and it's a quad rail.
-
5 November 2009, 18:40 #11Distinguished Member
- Join Date
- Aug 2007
- Posts
- 1,584
- Downloads
- 11
- Uploads
- 4
I just recently re-installed my MI FF rails onto my A4gery......