Results 1 to 15 of 17
Threaded View
-
2 December 2007, 11:25 #1
Refinishing AR15s with Norrells Moly Resin
I've been asked a few times about refinishing AR15s. I don't claim to be an expert, but mine have turned out well, and seem to be holding up to wear quite nicely. Here is how I do it.
To start, I picked up an airbrush kit. I had been told that ANY basic airbrush would work fine for spraying Norrells Moly Resin, so I went with the most basic version I could find. Oddly enough, that also meant the cheapest version I could find. Out to the local stores, and the Testors kit pictured below is what I am using. As it turns out, this little cheapo airbrush works very well.
Inside the box will be a small air canister, go ahead and pick up a larger can while you are there. Sooner or later you will need it, and the middle of a project is a bad time to go low on air...
Price for Testors Airbrush Kit-$20-25
Price for large air can- $6-7
Last edited by Stickman; 2 December 2007 at 11:57.