Worlds first RDS Equipped Kahr?

[goteron]

I have transitioned to Trijicon RMR's on all of my full size guns, but I still felt a disconnect between the full size and my Kahr. If I have a belt on, I carry a full size M&P 9 With TLR-3 and RMR. But if I have gym shorts on, its a belly band with a CW9 or CM9.

I have been wanting to try this for some time, but really got the bug last night, I drew the slide in solidworks and determined the best location for it. I havent shot it yet, but I forsee no issues.

Here you go:







I normally prefer the RMR, but the Deltapoint just fits so much better in this application.

I plan on getting a slightly taller front sight and milling a witness mark in the DeltaPoint (Pioneered by Bowie I believe)

[kingfisher2]

Nice work!

[Stickman]

I think this will start to become pretty standard in the next few years.

[BravoHotel]

I have to agree with Stick. OP - I see you drew it up in Solidworks so I'm assuming that means you milled it yourself?

I've been considering sending my slide of to Bowie for similar work however I would like to keep the rear iron sight on behind the red dot...preferably some slightly taller ones for the future silencer. Right now the mill work is just too cost prohibitive for me. Some day.

[goteron]

I did mill it myself, but I have a small tabletop manual mill and crummy cutters. I can do easy work like this, but nothing complex. I draw everything in solidworks these days, makes the execution so much easier.

I shot this on saturday, it worked great. Very happy with the outcome.

This is my carry gun, and likely the setup you are looking for (whether it be glock or M&P)

[BravoHotel]

Yep, that's what I was talking about. Looks good!