Results 196 to 210 of 496
-
22 January 2015, 21:42 #196
-
22 January 2015, 22:13 #197
-
23 January 2015, 04:55 #198
A machined into the barrel gas block could probably be made small enough to fit a barrel nut over. Inside diameter of a barrel nut is roughly 1", the barrel nut will not need any of the excess bottom material for set screws. So if the barrel was a .625, if you make the female end top part of the machined in gas block under .375" the barrel nut should still clear. Maybe a waste of time, but this could drop the swing weight of a barrel due to eliminating the material on the side both the bottom and sides of a gas block. Could also improve barrel harmonics, and possibly make the complete barrel assembly[barrel, gas block & muzzle device] weigh in somewhere around 24 oz. A BCM ELW fluted 14.5" with gas block and pinned muzzle device weighs in roughly at 26 oz.
I know this is the wrong section for this pic, but my machined in gas block would look something like this.
[IMG]Machined GB by gostsystems, on Flickr[/IMG]
-
23 January 2015, 08:19 #199
-
23 January 2015, 09:42 #200WEVO Spell Checker
- Join Date
- Sep 2014
- Location
- Florida
- Posts
- 3,198
- Downloads
- 1
- Uploads
- 0
-
23 January 2015, 10:11 #201
-
23 January 2015, 10:14 #202
-
23 January 2015, 10:20 #203
-
23 January 2015, 10:23 #204
-
3 February 2015, 01:32 #205
-
3 February 2015, 03:46 #206
-
7 February 2015, 19:51 #207
-
7 February 2015, 19:53 #208
-
7 February 2015, 19:55 #209
Wish I had gotten shots of the SBR today. I was expecting some noise but good lord!
-
7 February 2015, 20:17 #210