First Look - Fortis Manufacturing 14" REV™ Rail - Prototype

[zero7one]

I do not have a lot of information on the mid-length version of the Fortis Manufacturing Mid-Length REV Rail, though from my measurements, it is approximately 14.75" in overall length and somewhere around 11oz from my non-digital scale.

ETA: Just received an update from Fortis Mfg that stated that the rail is measured at 14" and weighs 10.4oz in the raw.

Here is a teaser photo of the prototype:


*Note...the rail does not have an anodized finish on the prototype.

[zero7one]

[Stickman]

How is it a midlength at almost 15"?

[zero7one]

How is it a midlength at almost 15"?

It is actually going to be listed as 14" and weighs 10.4oz. And I'm just going off the information that I have been given.

[freebug]

Awesome! I think DD has some work to do.

[CV1073]

do you know if there will be a model made for HK416/MR223/MR556?

[Stickman]

[angus_mackagen]

Anyone know if it'll fit on an LWRC upper?

[Computalotapus]

It is actually going to be listed as 14" and weighs 10.4oz. And I'm just going off the information that I have been given.

Thank's to you (you pointed out the ucwrg sets) the wife has picked out UCWRG lower/upper set and she is looking for a lightweight setup. This should do the trick.

[skd_tactical]

Anyone know if it'll fit on an LWRC upper?

It would not fit out of the box on my M6A2. Looks awesome, but the piston cup is too wide for the top part of the rail. There is a guy on the LWRCi forum that made it work, but he must have better machining skills than a dremel tool and some cinder blocks to hold it in place.

SOS

[Computalotapus]

This rail is now available in FDE on their website Fortis MFG

[UWone77]

Comp,

Good catch, yes they are available on Fortis Manufacturing and Rainier Arms' websites. MSRP $294.95