Magna-Matic Defense Precision Steel Dead-Blow Gunsmith Hammer (CLEAR ZINC)

[zero7one]

Unlike all other hammers out there, the PSDB is all-steel precision CNC machined hammer. No cheap wood handles or over-molded screws for tips. This is a serious hammer for serious gunsmithing - hitting pins, punches, whatever. The PSDB can have 3 different hammer tip materials “on-board” - one can be screwed into each side of the hammer head, and the third screws into the bottom of the handle. So no matter what type of pin, or against what finish you might have to hit you can pick a hard or soft non-marring hammer tip for the job. The tips are held tight with large o-rings, so they’ll never back-off and come loose. The PSDB is a whole new type of dead-blow hammer, with the PSDB Hammer from Magna-Matic Defense your not just pounding sand. Our dead-blow design incorporates a solid steel slug (rather than sand in most dead-blow hammers), this provides you with a kinetic transfer of energy that multiplies your hitting force. If you have a job where light gentle tapping is required, you can remove the steel slug, and store it in the handle of the PSDB. We have put tremendous thought into the design of this hammer, from the various curves in the handle allowing for numerous choked up hand positions for lighter tapping, or a full handle grip for maximum force. The end of our handle isn’t just a clever storage area for the steel slug when not in use, since we have the third hammer tip on the end of the handle, you can produce very light gentle tapping force with the end of the handle. PSDB Hammer Includes: Hammer body/handle One brass tip One hardened steel tip One delrin (plastic) tip One steel dead-blow slug.

Handle and hammer head are CLEAR ZINC plated. (silver colored)



Features

• All steel construction
• Precision CNC machined
• Made in the USA
• Interchangable tips
• Steel dead-blow slug
• Clear zinc plated for severe corrosion resistance
• Limited life-time warranty on hammer body

LINK

[UWone77]

I've had the pleasure of using the Magna Matic Defense hammer for the last 2 weeks. It is easily one of the best gunsmithing tools I've been able to use in a long time. The Hammer does what it's advertised to do, and has made pounding out push pins, and roll pins that much easier. It may not be for everyone, but if you're constantly working on your AR or other firearms, this is by far the best hammer you can buy. It also saves me from looking for a brass hammer or a plastic mallet, as the interchangeable screw on heads make it possible.

[M. Gale]

Need to visit WEVO more often. Thanks for the post. Just ordered one in black...

- Mark

[UWone77]

Put together another 2 uppers and lowers this past week with the help of this hammer. So far the biggest benefit for me has been the plastic end cap. I can never find the rubber mallet when I need it, so needless to say the plastic end cap has been abused.

[UWone77]

Now available at Brownells. If you qualify for the MIL/LE Discount, the hammer is a very affordable $54

Next to the Hammerhead tool, this is the other "must have" armorers tool in my opinion.

http://www.brownells.com/gunsmith-to...57974.aspx?avs