Results 1 to 8 of 8
Thread: Assembly Question
-
30 September 2013, 16:25 #1
Assembly Question
I actually shot a front pivot detent pin into space, and used the other one instead. Is the rear take down pin the same retaining pin as the front pivot pin? I'm assuming since the springs are the same size, so are the pins. I ordered a new AR Lower pin set from brownells, and it only has one of these pins in it. I couldn't find the stupid question thread, so I posted here. Again, for clarification, the detent pin for the rear take down pin is the same as the detent pin for the front pivot pin, correct? Thanks, I'd like to get this buffer tube on ASAP, as all of the parts finally came in for my build.
FT
-
30 September 2013, 16:45 #2
Yes, you can use the same detent for the forward and rear take down pins.
-
30 September 2013, 17:24 #3
-
30 September 2013, 18:33 #4
-
30 September 2013, 18:37 #5
-
30 September 2013, 18:45 #6
-
30 September 2013, 18:51 #7
-
30 September 2013, 18:56 #8