Results 46 to 51 of 51
-
3 September 2014, 09:40 #46
Sweet. Thanks!
-One Nation, Under God
-"The bad news is time flies. The good news is you're the pilot." ~ Michael Althsuler
-
14 September 2014, 13:41 #47
Anyone know I'd a Vltor .625 clamp on gas block will fit under one of these?
-One Nation, Under God
-"The bad news is time flies. The good news is you're the pilot." ~ Michael Althsuler
-
14 September 2014, 16:44 #48
-
14 September 2014, 16:55 #49
Under the .625? I'd read that about the .750...
A set screw .625 should be fine, but the clamping version looks like it sticks down a bit further. That's what I'm wondering about.-One Nation, Under God
-"The bad news is time flies. The good news is you're the pilot." ~ Michael Althsuler
-
14 September 2014, 17:16 #50
-
14 September 2014, 18:30 #51
Not the Vltors, they're one of the few companies who did it right, and didn't just bore a smaller hole in the same size blank.
-One Nation, Under God
-"The bad news is time flies. The good news is you're the pilot." ~ Michael Althsuler