Results 1 to 6 of 6
Thread: DD LITE Rail Help
-
20 September 2008, 18:48 #1disapproving_hooter Guest
DD LITE Rail Help
I can't get the bottom two screws in on my Daniel Defense LITE rail. They hit the sides of the lower. Suggestions?
-
20 September 2008, 21:26 #2
What upper are you using? Can you post a picture of the interference point?
-
21 September 2008, 05:25 #3disapproving_hooter Guest
It's a BCM. I can get some pics in a few
-
21 September 2008, 05:49 #4disapproving_hooter Guest
Nevermind, I'm a dumbass.
Last edited by disapproving_hooter; 21 September 2008 at 06:27.
-
21 September 2008, 06:35 #5
Are you installing the screws from the front end of the rail?
The two bottom screws on a DD Lite rail for an AR15 come in from the front. The other four come in from the rear end of the rail.
VA Arms Co FFL/SOT armorer
certified HK-sidearms/S&W M&P/BUSHMASTER/GLOCK/SIG-Sauer LE/FNH-SCAR armorer
competitive shooter sponsored by VA ArmsCo, W.A.R. rifles, BravoCoUSA, BCM, Bobro Engineering, Magpul, Magpul Dynamics, Hatfields Gunsmithing and Greeley Custom
-
22 September 2008, 19:19 #6
disapproving_hooter,
You aren't the first person, and won't be the last. When you finish up your build, make sure you show us a picture of your new creation.