Results 1 to 10 of 10
Thread: Extractor Wear??
-
28 May 2014, 18:04 #1
Extractor Wear??
has anyone seen wear like this on an extractor? Probably 500 round with this bolt and only used CLP for cleaning.
Just a regular guy.
-
29 May 2014, 14:14 #2
Kind of hard to see... looks like some discoloration?
-
29 May 2014, 16:37 #3
-
29 May 2014, 16:55 #4
Was this cerakoted or coated in any way?
-
29 May 2014, 18:31 #5
-
30 May 2014, 01:38 #6
-
3 October 2014, 21:50 #7New Member
- Join Date
- Oct 2014
- Posts
- 2
- Downloads
- 0
- Uploads
- 0
Looks an awful lot like a batch of gas blocks where I let the parkerizing bath get too hot. The coating flaked/dissolved off the steel very much like on your extractor.
-
3 October 2014, 21:52 #8
How long have you had it? Send it back to the manufacture
-
4 October 2014, 03:57 #9
Huh........i have a similiar deal with a new bolt also, with very little time on it..looks the very same...
-
4 October 2014, 06:30 #10
I had that bolt for a few months and probably 500 rounds through the weapon when it started acting up. The manufacturer replaced the bolt when I contacted them about it. The new bolt is still kicking and looks like it should
Sent from my Windows Phone 8.1Just a regular guy.