Results 31 to 45 of 82
Thread: Wanted: Actual OAL of Handguards
-
16 November 2014, 16:49 #31Contributing Member
- Join Date
- Oct 2012
- Posts
- 396
- Downloads
- 0
- Uploads
- 0
-
16 November 2014, 17:14 #32
-
16 November 2014, 17:17 #33
Can we get back to the topic where I was seeking help in finding actual handguard lengths and not go where it's heading with comments about my can.
-
16 November 2014, 17:35 #34
-
16 November 2014, 17:39 #35
This one is 7.25" long.
-
16 November 2014, 17:40 #36
-
16 November 2014, 17:46 #37
Here's are 2 from the uppers on my desk:
Knights Armament URX 3.1 13.5 = 13.5"
Rainier Arms 9" FORCE = 9.2"
-
16 November 2014, 18:03 #38
I have a 12" rainier force, 15" force, 12" seekins bar, and 15" parallax mlok. Will measure after the walking dead.
-
16 November 2014, 18:05 #39
-
16 November 2014, 19:13 #40
Well... Seekins must be a bit funky on their measuring. (Seekins makes the Rainier Force rails too)
Seekins BAR 12" - 12.5"
Rainier Force gen1 12" - 12.5"
Rainier Force gen1 15" - 15" (about 14 31/32, as close as you can get to 15")
Parallax MLOK 15"- 15"
-
16 November 2014, 19:17 #41
-
16 November 2014, 19:21 #42
-
16 November 2014, 19:35 #43
-
16 November 2014, 19:40 #44
We've already gone through that and he said he didn't want to cover up 'any' of the can...I personally think it would be fine... the 9" version that is, but you would have to get your fingers inside the rail a little bit to take the can off or put it on. I don't know, maybe it might be a tight fit... who knows... options are definitely limited.
-
16 November 2014, 19:44 #45
He only does a 7" and a 9" and I doubt the 7" would be over 7.75"? Glen said he thought the 7" might be like 3/8" over the 7" but he didn't have one lying around to measure. I might be able to make it work if it was like 1/8" too long, but any more than that and I'm concerned my sausage fingers won't be able to tighten it down very well.