Just got the Dillon 650 fully set up today. I started prepping my brass, and I'm going to run the press as a single stage for a while just focusing on one step at a time. Tumbled a few loads of brass yesterday and today and ran a few cases through the resizing die. I have two sets of dies on hand, Lee and RCBS. I'm borrowing these dies for now, I'll get dillon 3 die set eventually.

First question, and I'm sure I'll add more when I get more time to do the next steps...

Does this brass look correct? I know I need to get a case gauge, but generally does the neck of this resized case look like it should after resizing? Resized one is on the right.




If this doesn't look correct, can you tell me what I need to do to adjust the die? Cases came out looking the same from both dies after setting them according to the instructions in the dillon press manual.