Results 1 to 15 of 52
Thread: Encountered problems today
-
26 April 2015, 13:08 #1Senior Member
- Join Date
- Sep 2014
- Posts
- 556
- Downloads
- 0
- Uploads
- 0
Encountered a problem today
First time I've had issues with any of my builds. The gun in question is my 11.5" SBR with a BCM LW bbl, Vltor upoper and San Tan lower. BCG is BCM. I guess the problem is FTE/Double (?) feed. Spent case wasn't fully ejecting but at the same time the BCG was trying to chamber the next round. Only had the problem when firing rapidly.
Have about 1500 rounds on the setup and could replicate the problem with 3 different mags.
Thoughts?
-
26 April 2015, 13:09 #2Senior Member
- Join Date
- Sep 2014
- Posts
- 556
- Downloads
- 0
- Uploads
- 0
OTOH, my new 300 build ran great!
-
26 April 2015, 13:15 #3
Standard gas block or an adjustable? Also what ammo?
-
26 April 2015, 13:18 #4Senior Member
- Join Date
- Sep 2014
- Posts
- 556
- Downloads
- 0
- Uploads
- 0
-
26 April 2015, 13:20 #5
And you've run 1500 rounds fine and now you're getting issues?
-
26 April 2015, 13:24 #6Senior Member
- Join Date
- Sep 2014
- Posts
- 556
- Downloads
- 0
- Uploads
- 0
-
26 April 2015, 13:30 #7
Not sure how old the BCG is, but maybe the extractor spring is worn? But if it has only seen 1500 rds, that shouldn't be a problem.
Did you try a different BCG yet? Or only different mags?
Is it possible that timing could be an issue, since it's an SBR?
-
26 April 2015, 13:32 #8
So you had some failures to eject? Is it possible to swap out the bolt or BCG to narrow down the issues?
-
26 April 2015, 13:43 #9
Have you tried a deep clean of the chamber?
-
26 April 2015, 13:48 #10Senior Member
- Join Date
- Sep 2014
- Posts
- 556
- Downloads
- 0
- Uploads
- 0
-
26 April 2015, 13:49 #11Senior Member
- Join Date
- Sep 2014
- Posts
- 556
- Downloads
- 0
- Uploads
- 0
-
26 April 2015, 13:55 #12
-
26 April 2015, 14:05 #13Senior Member
- Join Date
- Sep 2014
- Posts
- 556
- Downloads
- 0
- Uploads
- 0
I'll swab the bbl and clean around the extension with qtips. Didn't take my phone so no picks unfortunately. Last time it happened the brass was wedged pretty good on the upper side of the BCG. Took some force to dislodge it.
Last cleaning was with frog lube (first time using it) and I noticed today after the first mag that I was running it pretty wet. Too wet? Is that possible?
-
26 April 2015, 14:16 #14
-
26 April 2015, 14:20 #15Senior Member
- Join Date
- Sep 2014
- Posts
- 556
- Downloads
- 0
- Uploads
- 0
It's sorta pasty I guess. More like a gel