Results 1 to 8 of 8
Thread: Magpul front sight question
-
2 June 2015, 01:25 #1New Member
- Join Date
- Jun 2015
- Posts
- 8
- Downloads
- 0
- Uploads
- 0
Magpul front sight question
Hi all,
Has any one encountered where it take 2 fingers on both side to release the Magpul front sight? It just started doing that on a new Fortis rail I installed. Is it because the width of the rail???
The rear sight is perfectly fine by pushing one side.
Any advice?
-
2 June 2015, 01:34 #2
Yes, I think it may require some breaking in with some wd40. I just use the center button instead. (new polymer blend possibly?)
BRUUUHHHH....Do you EVEN OPERATE?!?!
-
2 June 2015, 01:36 #3New Member
- Join Date
- Jun 2015
- Posts
- 8
- Downloads
- 0
- Uploads
- 0
-
2 June 2015, 01:37 #4New Member
- Join Date
- Jun 2015
- Posts
- 8
- Downloads
- 0
- Uploads
- 0
-
2 June 2015, 01:46 #5New Member
- Join Date
- Jun 2015
- Posts
- 8
- Downloads
- 0
- Uploads
- 0
COLT LE6920 BASE
MAGPUL CTR STOCK
ERGO GRIP / ERGO MAG GRIP
KNS JESSE JAMES ANTI R PINS (BEST LOOKING PINS EVER)
SPIKE BATTLE TRIGGER WITH JP 3.5-4.5 SPRINGS
SPIKE T2 BUFFER
WMD NIB BCG
HEX MAG 10/30
FORTIS 14" REV 1
SPIKE DYNA COMP BREAK
LOW PROFILE GAS BLOCK
TROY AMBI LEVER
BCM GUN FIGHER CHARGING LEVER
SIGHT MARK QD RED DOT
MAGPUL FRONT REAR SIGHT
This is the best BANG for you buck gun as it gets. Awaiting one last fortis grip and all done. Mil Spec = Best quality for the money
This is V-spec. Value spec. hahahaha
-
2 June 2015, 01:47 #6New Member
- Join Date
- Jun 2015
- Posts
- 8
- Downloads
- 0
- Uploads
- 0
its not stuck, the plastic is bending but the sight doesn't release. The right side works fine now, only the left sight, I just can't seem to figure out the physics when looking at it.
-
2 June 2015, 02:42 #7
My Magpul MBUS sights deploy when left, right, or center are pressed. Maybe the mounting screw is too tight? They are polymer, and over-tightening the screw could distort them enough to cause binding when you're trying to deploy them.
"It's time to start slapping people." - George Carlin
NRA Life Member | SAF Life Member | FPC Member
ΜΟΛΩΝ ΛΑΒΕ
-
2 June 2015, 02:51 #8New Member
- Join Date
- Jun 2015
- Posts
- 8
- Downloads
- 0
- Uploads
- 0
Lubed the plastic notches. Problem solved. haha