Results 61 to 65 of 65
Thread: SBR Discussion-- My Build
-
17 December 2015, 17:34 #61
shifting gears here a little bit.
I am putting together my lower and I have a few observations.
First off the bolt catch/release pin... CMT beefed that up alot than what they had with the previous models (which apparently I now have one of each). It's a welcome change albeit for my purposes a minor one.
I bought a battle arms mag release button and I like it a lot better than the seekins one. I know it's a small thing, but small things matter.
I also bought a bunch of strike industries stuff... springs, detents, mag release, take down pins, plungers, all that stuff, that little piece that holds your buffer in place (and spring)... man, I am telling you... for small parts I personally can tell a difference. The stuff they sent me was all extremely quality. If you are looking for mix and match parts for a lower build... after today... I wouldn't even think of looking past Strike Industries. To me there is a noticeable difference.
I just thought I would pass that along.
-
17 December 2015, 19:04 #62
Good info on Strike. I was swapping lower parts this week, and zing, lost a pivot spring and detent. Found the detent right away, found the spring yesterday. The Brownells tool is great, just remember to rotate down before removing it.
-
18 December 2015, 09:53 #63Contributing Member
- Join Date
- Apr 2015
- Location
- PNW
- Posts
- 177
- Downloads
- 0
- Uploads
- 0
I've been wanting to get my hands on some of the Strike Industries stuff. I'll have to move that up the priority list.
-
18 December 2015, 10:26 #64
-
18 December 2015, 14:07 #65Contributing Member
- Join Date
- Apr 2015
- Location
- PNW
- Posts
- 177
- Downloads
- 0
- Uploads
- 0