Results 1 to 10 of 10
-
15 April 2016, 13:13 #1
Midwest Industries NEW Benelli M4 Aimpoint Micro mount
Midwest Industries NEW Benelli M4 Aimpoint Micro mount will allow you to co witness your Aimpoint T1, T2 and clones.
This mount will retail for $79.95
-
15 April 2016, 13:37 #2
Looks good guys. Is it compatible with the IOCover?
-
15 April 2016, 14:32 #3
Just about every Benelli made in the past 20 years has used the same optic rail pattern. Any reason this is being marketed as just for the M4?
-
16 April 2016, 06:47 #4
-
17 April 2016, 21:02 #5
So.... I can also use this on my M1 Super 90?
-
18 April 2016, 08:09 #6
If you're willing to drill and tap the receiver I have an M1 Super 90 too, a decade ago I bought a B&T railed handguard. Together with an Aimpoint M2, there was too much weight added to the shotgun and it could not reliably cycle. Removing the Aimpoint solved the problem, but there wasn't much point in having the railed handguard then. The mini red dot sights at the time weren't all that robust, maybe I'll dust it off and try it again with an RMR this time :)
-
18 April 2016, 19:52 #7
That's interesting. I don't have anything added to my M1, but it cycles everything, including handicap and Xtra-light AA target loads. Don't recall the shot weight though.
I just haven't seen the ammo sensitivity with my M1 that others have reported. I may just go ahead and try it, eventually.. Still hoarding for the Hilliaryaclypse.
-
5 June 2016, 06:53 #8Senior Member
- Join Date
- Jul 2013
- Location
- Bentonville,AR
- Posts
- 783
- Downloads
- 0
- Uploads
- 0
Does this ACTUALLY co-witness? Can we see a view of the ALIGNED irons THROUGH the T2, please?
-
6 June 2016, 05:19 #9
-
11 June 2016, 06:28 #10Senior Member
- Join Date
- Jul 2013
- Location
- Bentonville,AR
- Posts
- 783
- Downloads
- 0
- Uploads
- 0