Results 1 to 15 of 17
Threaded View
-
25 June 2016, 16:40 #1
9mm lower bolt catch has me flummoxed
My stripped PSA 9mm lower came with the bolt catch roll pin all the way in. (See photo from site) Any ideas how I am supposed to get it out enough to install the bolt catch assembly? The forward hole dead ends so I can"t just punch it out. Too snug for needlenose to slide out. And it doesn't look to be a screw out type that I can tell. Smaller than my tiniest allen wrench.
Just emailed PSA, but I'm irked having to wait for reg business hours. Especially if the solution is something simple my old noodle just can't process.
The two screws forward have no connection to bolt catch.
“ When I comes to modern politics, I think the inverse of Hanlon's Razor applies...In other words, "Never attribute to stupidity that which is adequately explained by malice." - Kerplode