Results 1 to 3 of 3
Thread: SMOS Part 2
-
29 August 2016, 16:14 #1
Senior Member
- Join Date
- May 2013
- Posts
- 820
- Downloads
- 0
- Uploads
- 0
SMOS Part 2
So this is almost complete. Just looking for glass to top it off. Probably going to go with a Vortex Strike Eagle 1-6. So here is my parts list:
SMOS GFY Receiver Builder's Pack (13.75" rail)
Lower Parts:
- BAD adjustable pistol grip.
- Mil spec 7075 receiver extension with H buffer (Titanium QD endplate)
- CMMG LPK (Odin Works V2 mag release and Strike Industries Chrome extended takedown pins)
- Ruger 2 stage FCG
- Magpul STR (may swap for an ACS)
Upper Parts:
- Strike industries Ejection port door
- BCM Medium Latch CH
- Toolcraft/Cryptic coatings Nitride BCG with c158 bolt
- Larue 16" PredatAR barrel
- SLR micro gas block
- Rainier Arms RMC v2 (waiting for it to arrive)
The last picture was just some of the lowers I picked up "just in case."
-
29 August 2016, 16:28 #2
Elite Member
- Join Date
- Mar 2013
- Location
- The Unfree State (MD)
- Posts
- 2,731
- Downloads
- 3
- Uploads
- 0
Nice. Those barrels are shooters.
-
20 September 2016, 06:05 #3
WEVO Staff Photographer
- Join Date
- Nov 2013
- Location
- SE MI
- Posts
- 4,571
- Downloads
- 2
- Uploads
- 0
Lookin good so far
Ground Defense 1, Blade Defense 1, Defensive Pistol 1 & 2, Aliance Shoot House, When Things Go Bad, YSINTG, Carbine 1, DART Medical, NRA Range Safety Officer
david@damagephotos.com
Damage Photos on Facebook
@damage_photos on Instagram
Use DAMAGE15 to save 15% at Third Pin Threads
Save 10% "JOINORDIE" http://cmttac.com/
Reply With Quote
