If you ordered one of the new Gen2 polymer frames from Rainer, what are your plans for it. I'm still pretty vague about specifics, especially the lower parts, but my plans are to send it to Battle Cock first, mill the frame when it gets back, install the supplied parts, and piece together the upper. I'm going (I hope) to get a 32 slide, barrel, etc.. and put together a .357 Sig, a caliber I've never owned, and probably just a subdued cerekote job that a friend will probably do for free or cheap.

As for a trigger, I'm going to lean towards reliability over flash, and I'm not sure at this point what that will be, or maybe it will be stock with the FT 37 cent trigger job (I go a little beyond the standard .25 cent trigger job that's been around forever)

So a cool, functional stippling job, OD cerekoted slide in .357sig and keep it simple and clean, is what I'm going to go for.

FT