Head scratcher...

[Joelski]

Okay, I'm not a total noob, but this time it feels like it. I bought some BAD enhanced pivot and takedown pins and the takedown is easy, but short of cutting off the old pin, how the hell do I get the retainer pin and spring out?

I have put things on backward (and liked it!), I've installed completely un-necessary parts for no good reason. I submit to you, the experts with hat in hand and humility laid bare. Be gentle with the baby, Ward. You were here once!

At least by the time I get to the firing line, it goes BANG! instead of KA-BOOM!

[six8]

Too late now the pins are useless. Send them to me 😁


Sent from my iPhone using Tapatalk

[GOST]

Pull your pivot pin out till it stops. There should be a small hole in your pivot pin that now lines up with the detent. Insert something like a paper clip into the hole to disengage the detent. Once detent is disengaged spin the pin so that the detent is no longer in the channel and pull the pin out.

[Slippers]

And use another pin or appropriate sized shank on a drill bit from the opposite side to keep the detent and spring from flying out. Then you can easily insert the new pin.

[RogerRonas]

This is how I do it. ^^ above 2 posts.

[Dstrbdmedic167]

Yea I do the paper clip the few times I've removed them. Standard bad pins have the magnet and makes for a super quick and easy installation

[Joelski]

Thanks guys!

[din]

Which gun are the new pins going in?

[Aberration79]

Youtube it. Video is worth a million words.