Results 1 to 7 of 7
Thread: PEW PDW
-
30 May 2020, 20:14 #1
PEW PDW
Finished up a PDW pistol in 300 BLK using an Aero PEW lower (at wife's request).
Barrel is 6 inches (IIRC) with a Griffin Armament taper mount liner comp / suppressor mount that just barely clears the handguard.
I think I'm going to put an BCM KAG on it so I have a good reference point to keep from getting a hand over the barrel and want to put a caliber marked dust cover on it since it's not 5.56/.223, but I think this is otherwise done.
Doesn't scrunch up as tight as an MP5K, but with the stock out and suppressed it's in the ballpark.
-
30 May 2020, 20:25 #2
I have a soft spot for the SRS. I wish I had picked one up.
Very tastefully done!
-
30 May 2020, 21:58 #3
Thanks, UW.
The SRS was inspired by Sicario
I picked up a used on Gunbroker. I tend to like EOTechs over RDS, but I like the big window on the SRS. The controls suck, but Trijicon *almost* got this right. I think they gave up on it too soon and if they addressed some of the common complaints I think this would have done a lot better in the market.
-
3 June 2020, 23:32 #4
So how is it with the 6” barrel? Assume your only shooting it with a can?
-
7 June 2020, 21:17 #5
Actually, primarily built it up to be a non-NFA shooter for a vehicle gun. I wanted a linear comp anyway so was pretty happy when I realized that GA makes a taper mount liner comp.
Put some rounds through it over the weekend More fireball than I was expecting but functions fine with S&B 125 gr and my 110gr reloads. My 220 gr reloads were short stroking, though. If I add powder they'll go super in my 8", so not sure what I want to do here. Will try out some factory subs.
-
7 June 2020, 22:38 #6
-
8 June 2020, 06:56 #7