On a side note, I tried 'thread sealant' for a couple of my suppressors. Specifically on the Revolution 9--the end cap is the critical part that puts tension on the baffle stack so I wanted to make sure that it didn't work loose or anything.

The stuff works, but man, it was a PITA to get it apart once its set. Basically I had to use solvents to get it to come apart. Basically it was like it was really carbon locked on there, except it was the thread sealant. Getting that end cap off was a multiple day ordeal of soaking and so forth. That being said I didn't know what to use to undo it so I tried a few options.

Another 'issue' is the end cap doesn't have anything you can put a wrench on so I was a bit limited there.

This is the stuff I used:

https://www.permatex.com/products/th...-sealant-6-ml/