Results 931 to 945 of 1819
Thread: Handgun Picture thread
-
25 February 2016, 16:12 #931
No worries. The only safety on this is the trigger, other than the end user.
There's no "Team" in F**K YOU!
-
27 February 2016, 08:22 #932
All back together, about to hit the backyard range to try that new trigger setup. SA may end up being a bit too light with that 17lb mainspring. The GGI adjustable trigger zeroed any overtravel in SA. It's like a different gun. Now to get my other set of factory grips off to Senor BattleCock....
220 fixed 2 (1 of 1) by Steven Ragan, on Flickr
-
27 February 2016, 12:17 #933
-
27 February 2016, 13:27 #934
-
27 February 2016, 21:32 #935
-
27 February 2016, 21:42 #936
-
27 February 2016, 21:43 #937
-
27 February 2016, 21:46 #938
-
27 February 2016, 21:57 #939
Yep, the Rev 9. Totally happy with it.
“ When I comes to modern politics, I think the inverse of Hanlon's Razor applies...In other words, "Never attribute to stupidity that which is adequately explained by malice." - Kerplode
-
27 February 2016, 22:05 #940
-
27 February 2016, 22:27 #941
-
27 February 2016, 23:57 #942
Nice M&p's..where's the fde one for the trio ...
But where is the trigger upgrades on those bad boys, loved the ergos of these but when I swapped out the stock for the apex stuff, totally different and much more enjoyable shooting gun all around..
I want another m&p 9, such a good shooter and just a better grip
Lol...
I'm catching on to you now....Lolol
-
28 February 2016, 03:43 #943
Well, it's my first can so I can't compare with others. Positives are: does not feel all that front heavy; suppresses well with 147 gr - better on Sig than Glock 19; does not seem to shift POI much that I can tell. Feels extremely well machined. I did have to buy a separate metric piston. Comes with 1/2x28.
Periodically check tightness of the front cap. (thinking safe practices) It may vibrate loose. Ditto can itself after a few shots from cold and every mag or two. Maybe I'm paranoid about damaging. Shooting gloves NOT enough insulation. When done firing, at least crack the can open a half turn to break the seal. Seems more an issue with the taper mount rifle can. I keep threads and taper surface lubed with Aeroshell barrel grease. Others with experience may have better ideas.
Factory Glock high sights do not rise above can surface. But I seem to shoot as well can on or off. Same with standard Sig sights. At least at shorter distances.“ When I comes to modern politics, I think the inverse of Hanlon's Razor applies...In other words, "Never attribute to stupidity that which is adequately explained by malice." - Kerplode
-
28 February 2016, 06:15 #944
Sent from my XT1254 using Tapatalk
-
28 February 2016, 06:16 #945
Sent from my XT1254 using Tapatalk