Results 1 to 9 of 9
Thread: What handguard for 8 barrel
-
15 June 2020, 09:04 #1
What handguard for 8 barrel
Kinda brainstorming, and havent really built anything this short yet. So say one was gonna use an 8 barrel- like the RA nitride- https://www.rainierarms.com/rainier-...de-non-fluted/
What handguard length would be MAX for such a length if using a can, not tucked or anything but close to end.
7.5 too close?
-
15 June 2020, 09:13 #2
I have multiple handguards (Noveske, CMT, KAC) a half inch shorter than barrel length and they fit perfectly.
The decision is based on how far your muzzle device indexes off the barrel shoulder. My dead air mounts index far enough that the can doesnt touch the handguard with the keymo mount.
YMMV depending on which mount you use and how the can mounts.
Id measure a barrel with the mount and can of choice on it. See how much gap sits between shoulder and can. Thatll give your answer. Some cans cans go on further back and snug forward so you need to account for that too.
-
15 June 2020, 09:50 #3
Good info fledge.
I thought about whole mock up thing, but all kinds of stuff is out of stock..lol
No 300 blackout ammo worth a shit with a quick google...fackkk
No yhm QD mounts In stock (waiting for Kurz kits to come back in stock)
So, just spitballing..but didn’t think about the ammo being gone..so..
-
15 June 2020, 09:52 #4
As I got an extra upper and bcg (and gas block-if I replace 308 with adj. one) ..blah blah......lol...........so I figured with a incoming can Id take advantage and build a cheap decent blackout upper for shits and giggles..
No ammo or cases..had a 16 years ago but lost interest as no can to take advantage
-
15 June 2020, 19:07 #5
Make sure you get exact measurements from manufacturers you're looking at. Some 7" are actually 7.2" ect.
-
15 June 2020, 20:12 #6
The Aero Precision 7" handguards are 7.25" and the BCM 7" handguards are 7.39". Either of those should work fine on an 8" barrel
-
16 June 2020, 06:36 #7
8.3” Ballistic Advantage 300BLK Hanson with 7.5” SLR
-
16 June 2020, 07:29 #8
I need to finally get an SLR receiver set. Those are sexy.
-
25 June 2020, 03:27 #9
That’s rad..nice pistola