Holster Picture Gallery

[Computalotapus]

Armordillo Concealment XFER for X300 Ultra in FDE...

10-8 Performance M&P9 by Triple Bravo, on Flickr

Booth makes some awesome Kydex

[Computalotapus]

After messing around for months and months with Kydex I finally have a design I like. This will be put on a HSGI mini drop leg panel. I will wear it about mid/low hip (about same height as my front pocket). It has a slight cant to it so moving the holster to OWB is easy but not enough cant to make drawing from the drop leg an issue. I have been running around without a mag carrier so I decided to fix that as well. Waiting on mounting hardware to get here from diyholsters.com and the mini drop leg panel as well.

[GOST]

After messing around for months and months with Kydex I finally have a design I like. This will be put on a HSGI mini drop leg panel. I will wear it about mid/low hip (about same height as my front pocket). It has a slight cant to it so moving the holster to OWB is easy but not enough cant to make drawing from the drop leg an issue. I have been running around without a mag carrier so I decided to fix that as well. Waiting on mounting hardware to get here from diyholsters.com and the mini drop leg panel as well.

Where's the golfer's belt?

[mustangfreek]

Nice job!!

[browcs]

Excellent job Comp! Bravo!

[tact]

That looks really nice!

[Computalotapus]

Thanks guys. I want to run it for awhile test and tune
Sent from my Windows Phone 8.1

[Computalotapus]

Finally got all the mounting hardware in for the holster and the mini drop leg panel. Assembled it all and tested fit and function. Ran up and down the stairs to make sure the weapon didn't wiggle around on the drop leg panel. Feels pretty solid to me. With the slight cant the setup forces the trigger finger to index at the top of the slide so no mishaps when drawing.

Will get it out to the range and run it through some stages to see if I want to change anything. Been working on this setup for a very long time. Lets hope it pays off.

[UWone77]

Finally got all the mounting hardware in for the holster and the mini drop leg panel. Assembled it all and tested fit and function. Ran up and down the stairs to make sure the weapon didn't wiggle around on the drop leg panel. Feels pretty solid to me. With the slight cant the setup forces the trigger finger to index at the top of the slide so no mishaps when drawing.

Will get it out to the range and run it through some stages to see if I want to change anything. Been working on this setup for a very long time. Lets hope it pays off.

How did you attach the holster to the leg rig, MOLLE? Any concerns about retention on a drop leg?

[Computalotapus]

How did you attach the holster to the leg rig, MOLLE? Any concerns about retention on a drop leg?

This setup has MALICE loops (pull tab) attached. Going to try out the new M-LOK system. This is my competition rig so for retention just made it a little tighter than what I would use on a OWB setup. If I was to set one up for a LEO I would configure it with a thumb break snap as well as the tighter retention just to be safe.

[schambers]

thats really impressive

[browcs]

Very nice Comp! Very nice indeed!

[Computalotapus]

G19 OWB (new infinity symbol presses out really nice)

[GOST]

The infinity symbol is a nice touch.

[mustangfreek]

Not the best pic, but wanted to show my New OWB holster a friend made for me , for my Full size m&p...been wearing it around all day, and so far feels really good, nice fit, snug to the body...and he's member here..Thanks....

The color is a coyote brown, i just couldnt capture the color very well..