Results 106 to 120 of 129
Thread: Reloading Components
-
13 February 2018, 18:53 #106
Over this past weekend I shot three 5-shot groups with 77 gr CC, LC 11 brass, and 24 grains of varget with each of CCI 400, CCI #41, and Rem 7 1/2 primers. The Rem 7 1/2 was the tightest group. Looks like #41s gave the highest velocity but with a lot of variation. Unfortunately I only got chrono readings off of 1 of the shots from the 7 1/2 set, but I think I'll focus on those for a bit.
-
22 February 2018, 23:29 #107
Nice..
I tried about all of the primers and out of about everything cci 450’s gave me the best results with low deviation.
-
23 February 2018, 20:59 #108
-
6 April 2018, 18:07 #109
77gr Nosler CC (thanks Will)
Lake City ‘17 brass
FGMM brass
23.6gr Reloder 15
-
6 April 2018, 21:59 #110
-
7 April 2018, 18:51 #111
-
10 May 2018, 13:55 #112
With my 16” Ultramatch Mod 2 today.
-
10 May 2018, 16:28 #113
That’s gotta feel good. Nice load and shooting.
-
10 May 2018, 18:38 #114
-
7 August 2018, 14:53 #115
-
25 September 2018, 06:47 #116
Got my dies sorted and my .224 Valkyrie loading days have begun
-
22 October 2018, 08:27 #117
.50 B&M Alaskan. The flat point and cup point bullets are made by North Fork bullets, and both 450gr solid copper projectiles. They’re loaded with either 63gr of IMR 4198 or 62gr of Reloder10x and traveling about 2000fps
The Tipped bullet is a 300gr Hornady FTX .50 cal with 69gr of IMR 4198 at about 2400fps
-
31 December 2018, 10:36 #118
Turning money into noise!! I love it
-
31 December 2018, 14:48 #119
-
1 January 2019, 00:16 #120
Nice!