Ok so doing the function check the other night on the lower everything went fine. One thing I did notice was that when I cocked the hammer (trigger not depressed) if I pushed the hammer past the initial catch point the hammer shelf would contact the disconnector. It wouldn't stick as if I had the trigger held down but it would click going down and back up to the catch point. I contacted Bill Springfield and he said he set it up this way as extra insurance against a double fire. While I take his word I am just curious how that tiny bit of contact does anything to prevent a double fire. Ideas?


Btw - the trigger pretravel is perfect.. no creep at all and a very crisp break.