Results 31 to 45 of 56
-
5 February 2016, 04:08 #31
I had a DD low pro gas block and it didn't even remotely clear it so I decided to purchase a gas block directly from to make sure it had no such issues, unfortunately that wasnt the case.
I have photos that I may post later. I will do a whole review of the gas block and rail together before I ship them out.
-
5 February 2016, 04:17 #32
Yeah, the DD blocks are on the large side. Still surprises me that the Sentry won't clear an SLR rail. I wonder if any block clears without touching? I built up an 18" Noveske for a friend last year with a pinned Noveske block and an SLR Rifleworks rail. I don't recall that one having any issues.
-
5 February 2016, 04:33 #33
-
5 February 2016, 04:56 #34
What receiver? Could thr barrel nut threads not be perpendicular with the face of it? Could it have been previously damaged? Sounds like an issue with the mounting point...
There's no "Team" in F**K YOU!
-
5 February 2016, 05:08 #35
-
5 February 2016, 05:23 #36
-
5 February 2016, 05:25 #37
-
5 February 2016, 07:08 #38
-
5 February 2016, 07:20 #39
I've seen that before with URX rails. You can see the rail misalignment, if it exists, by eyeballing it from the muzzle. But it honestly just sounds like the internal diameter of the rail is small. I've run into the same issue with a Centurion CMR before. Skinny rail, skinny internal dims, needs a really slim GB to free float.
-
5 February 2016, 07:39 #40
Yes, the ID on the SLR rails is very small, just like an original CMR. Newer CMRs are opened up a bit. You almost have to use a gas block for a .625 journal (that isn't the same OD as a .750 gas block), or a shaved FSB. Badger also makes a very, very low profile gas block, smaller on the bottom than anything else I've seen.
Will - Owner of Arisaka LLC - http://www.arisakadefense.com
-
5 February 2016, 07:55 #41
-
5 February 2016, 08:15 #42
Just a FYI, the CMMG micro's are the smallest gas blocks I have ever found. PRI makes a very compact one also but they are often very hard to find.
-
6 February 2016, 06:40 #43
Ballistic advantage makes a real low profile gas block as well. http://ballisticadvantage.com/750-lo-pro-gas-block.html
The best way to survive a violent encounter is to be the one inflicting the most violence.
-
6 February 2016, 07:09 #44
I'm not going to be putting it back together, and I'll be selling the slr rail and the gas block with a disclaimer attached. I'll actually be doing a write-up on the whole thing on my site before I do so - Now that I know of an issue I would consider myself at fault if others experience it when they could have been educated.
-
6 February 2016, 07:51 #45
How much you asking for the gas block?