Results 46 to 56 of 56
Thread: 300 blackout supersonic loads
-
7 September 2015, 09:46 #46
-
7 September 2015, 09:53 #47
-
7 September 2015, 09:56 #48
-
7 September 2015, 10:14 #49
Any round that can't inadvertanly blow up a weapon is a pussy round in my book.
Hahahaha
I'd like to see those pics also. They may be the ones I recall seeing a few years back.
-
7 September 2015, 10:53 #50
and that right there is why I crimp my reloads. People will argue if it's needed or not, but for me it's 100% required. I tested a load (believe it was Barnes 110g TAC-TX) and with a case that had less neck tension while seating the bullet, and no crimp, I was able to get it into battery with no problem. Everything gets a crimp... period.
And I use different brands and colors for my calibers ... black Pmag =5.56, FDE Lancer = 300BLK, grey aluminum = 458Socom - not that the Socom could chamber in anything else! LOL-----------------------------------------------
Jim
"You can never have too many guns" - my wife's actual comment
Alaska Fun
-
11 September 2015, 10:10 #51
-
10 March 2016, 02:59 #52
Reviving ...as finally got my bo upper together and got a few test rounds thru it, and so hung out in the garage and setup and made some test loads
Hornady dies w/ lee FCD - 1/2 turn'ish
Mixed brass trimmed to 1.358
Hornady 150gr fmj
H110
15.4
15.8
16.2
Seated to 2.075
Hoping to get out soon and test these, no chrono yet , just results and watching the brass for now and then have a few other boolits and some aa1680 powder
-
10 March 2016, 03:15 #53
Mustangfreek, just as an FYI, you're using the same bullet, powder and OAL as I do. My test ladder was also almost identical to yours except that I topped out at 16.4gr. 15.8gr ended up giving me the best accuracy through my barrel. Unfortunately I don't have a chrono either since I can't use one at the range where I shoot.
"Never forget those who have died; Never forget who killed them."
-Unknown
-
11 March 2016, 02:01 #54
-
13 March 2016, 04:20 #55
Well between rain squalls and snow flurries got some testing in and the 15.8 load seemed to be pretty good, nice little group at 50 yards and eject, Bolt held open etc, the higher load shot about the same but started flattening primers and pretty noticeable ejector swipe. This is just a blaster load so I'll load up some more of these.
Also have some 110 varmageddons and 125gr Nosler BT'd to play with and work up
-
31 March 2016, 02:59 #56
Bump..Anyone using H-110 and. 110gr Nosler varmageddons ?
Sime of the data from the 110 vmax to to Nosler is quite a bit, no chrono but played with some test loads today with the 16" BHW barrel today with decent results
What 110gr Nosler or vmax -h110 recipes - chrono data/barrel length.