Results 76 to 84 of 84
-
3 September 2009, 15:42 #76
-
5 September 2009, 10:04 #77Member
- Join Date
- Apr 2008
- Posts
- 1
- Downloads
- 0
- Uploads
- 0
For those with GEN 2 KNS pins, the BAD lever does not make contact with the pin when engaged. At least on mine
pic of B.A.D. engaged to lock bolt back. it does not make contact with the pin.
edit 9/6/09: to add third pic.Last edited by monkeymeat; 6 September 2009 at 09:22. Reason: add pic
-
20 September 2009, 17:50 #78
Interesting that Tactical Link has just released their own version.
-
20 September 2009, 19:18 #79
And with a very original name...
-
22 September 2009, 15:59 #80
and Phase 5 just release a very cool "newer" version of their EBR v2. THIS is what I thought, was hoping, the BAD would be....
-
22 September 2009, 16:00 #81
-
23 September 2009, 05:35 #82
-
21 November 2009, 18:21 #83Member
- Join Date
- Nov 2009
- Posts
- 2
- Downloads
- 0
- Uploads
- 0
install process on magpul BAD
I got 2 magpul BADs in this week and I am not impressed with the installation process. I hope these images show up but when install them on a LMT MRP and my colt 6920, they both require me to mill the back plate to get them to fit and work properly.
colt 9620
with BAD stock
after milling the back side
finished
If i had installed it stock from the factory, the bolt would hold open. I had the grind down the back and put a curve on the bottom the of the back plate to get it fit.
On the lmt, i had the grind down the top of the back plate.
needless to say, the BAD does not fit all upper and if you were to buy them, make sure you buy from someone with a good return policy or be ready to do some grinding.Last edited by zephir; 21 November 2009 at 18:30.
-
21 November 2009, 23:14 #84Contributing Member
- Join Date
- Nov 2008
- Posts
- 371
- Downloads
- 0
- Uploads
- 0
I believe this a problem with fitting on all uppers. To me the modification is minor. Just a little grinding on a hand file and it was GTG.