Ejector Face Polishing

[Quib]

Deburing the ejector may be necessary in some circumstances.

I agree. This procedure is not always necessary.

New, Brand X ejectors often have a "tit" where two ejectors were separated along with rough edges. Armamlite ejectors are a good example.

Below are bolts from two of my other weapons (#1 & #2), along with the bolt that I polished the ejector on (#3).

Bolt #1 is unmodified. It does show very clearly the “tit”. But this “tit” is not as pronounced and is very flat. The edges of this ejector are slightly chamfered, and this bolt produces what I consider normal amounts of shavings. Mainly, as you pointed out above, shavings from the extractor.

Bolt #2 is unmodified as well. It shows very little if any real evidence of a “tit” and has a very smooth factory face. The edges of this ejector are also factory chamfered very similar to the ejector that I personally chamfered and polished.

Bolt #3 is of course the ejector which I personally modified, and the one I used in my tutorial.