Results 1,636 to 1,650 of 2009
Thread: MAIL CALL
-
19 September 2019, 17:52 #1636
-
19 September 2019, 21:56 #1637
I was kind of wondering what kind of velocities your going to get from a 5.5" barrel... Doesnt seem like a TSX or bonded round would expand so far below their thresholds. Do you just run hot FMJ's and go for a critical organ or head shot.
I have been holding off on a 8.5" upper because I cant convince myself that the terminal velocities are worth it. 556 is all about speed...Last edited by Stone; 19 September 2019 at 22:01.
The best way to survive a violent encounter is to be the one inflicting the most violence.
-
19 September 2019, 23:34 #1638
-
20 September 2019, 23:28 #1639
Old Mail is still mail, right?
Only the LMT lower is new to the bench, all the tools (except the Mehew punch) have been previously acquired.Last edited by cjd3; 20 September 2019 at 23:33.
-
21 September 2019, 08:59 #1640
-
23 September 2019, 17:19 #1641
MAIL CALL
Didn't have much time to take a photo, but I'm super excited about this scope. 3-18x42 w/35mm tube.
Sent from my iPhone using Tapatalk
-
23 September 2019, 19:07 #1642
Man, that has my dream scope specs. I recently got a 4.5-18, but 3x on the low end would be choice.
“ When I comes to modern politics, I think the inverse of Hanlon's Razor applies...In other words, "Never attribute to stupidity that which is adequately explained by malice." - Kerplode
-
23 September 2019, 20:50 #1643
Phil - Thanks. I've been gunning for a deal on an IOR Valdada scope for a while, and it was worth the wait. I did some casual viewing with it a little before sunset tonight. Phenomenal glass! I was curious to see how such a comparatively small objective lens would stand up to my other scopes with 50mn to 56mm objective lenses. This scope gathers plenty of light.
Sent from my iPhone using Tapatalk
-
3 October 2019, 19:53 #1644
-
3 October 2019, 20:03 #1645
-
11 October 2019, 16:25 #1646
-
11 October 2019, 16:37 #1647
-
13 October 2019, 00:04 #1648
Look again...Those say for 16’s moxy..
-
13 October 2019, 17:16 #1649
-
15 October 2019, 19:43 #1650
Well, I finally get a turn at this. There's been a crap ton of overtime at work so Christmas has been a bit early.
This is my answer to recent legislation.
2019-07-27_04-43-01 by fairlanericky, on Flickr
Through one trade and 3 purchases, this is my starting point.
2019-07-06_12-41-27 by fairlanericky, on Flickr
A while back Samson Mfg. had a sale on Keymod rails so I picked up 4. Here's one of the 7.6" rails, along with some MFT goodies I got from UW awhile back.
2019-08-09_09-14-37 by fairlanericky, on Flickr
More parts and ammo to finish off the 8" 300BO.
2019-10-15_05-32-31 by fairlanericky, on Flickr
2019-10-15_07-10-16 by fairlanericky, on Flickr
Ric