Results 256 to 260 of 260
Thread: HK 416 Thread
-
31 October 2023, 03:17 #256
More than if I had piece-mealed it together with non A5 parts, but less or about the same as a clean factory A1 (A3?) in today's market.
I can't remember if it's that lower, but two of my Brownell's lowers have lower parts that aren't HK and are instead LMT or Colt parts. The 416 A1 lower has extra parts needed beyond a normal LPK. While far from perfect, the plus of the BRN lowers was that you didn't have to use those extra HK parts to make it work with a factory 416 (or MR556) if you didn't want to.
My OCD wouldn't allow that, but that's a different matter.
-
1 November 2023, 14:16 #257
The kind of OCD where you replace an awesome $200 BCG with a $350 BCG just because it matches the stamp on the mag well? ("Matching numbers" OCD).
Like, the kind of OCD where you replace an SSA-E with an SSAX-E? (New Hotness OCD,, [with underlying matching numbers OCD).
That kind of OCD?
Yeah, it sucks doesn't it?There's no "Team" in F**K YOU!
-
2 November 2023, 07:01 #258
I will say that even when I was more into cloning, I would still reach a point where I didn't "finish" the project because I would actually shoot my rifles and I couldn't stand using whatever the correct part was (like having MIADs on everything instead of correct A1 or A2 grips). That was always my line in the sand.
-
2 November 2023, 10:58 #259
-
2 November 2023, 17:45 #260