Results 46 to 60 of 84
-
6 September 2014, 06:09 #46
-
6 September 2014, 16:27 #47
So far...
I opted for an ALG ACT FCG and a BAD ASS 90 degree with cranks and an A5 receiver extension and buffer system. The rest are parts I had sitting around. I did try a Seekins "enhanced" bolt catch but the hole wasn't big enough to prevent binding on the roll pin. When I measured it, it was a few thousandths off. It will be cheaper to just drill it rather than send it back. The upper is a BCM blem I had in the drawer -- fits perfectly. Still haven't decided on a barrel yet. Very interested in a Sionics melanite, but haven't seen any long term use info on them yet.
-
6 September 2014, 21:16 #48
-
6 September 2014, 22:03 #49
Stock will probably be a CTR. I have one on an SBR and like it fine. Barrel, forearm and optic will be defined by the rifle's purpose, once I decide what that is. I'm kind of interested in the Giessele rails and Sionics barrels. My only 16 inch rifle has a VIS upper and it's kind of heavy.
-
7 September 2014, 03:45 #50
I've got a 13" Geissele MK4 on a 14.5". My BAD-15 lower is going to be a 11.5". I'm considering a 10.75" URX4 and the CMR, but I've got sometime to kill.
-
7 September 2014, 06:45 #51
Hmac, is that lower on the Rainier Upper you got from the last giveaway?
GOST, that's the same upper that RA used in the picture with the Battle Arms Lower. Looks like they match up pretty well. In my opinion the Battle Arms lower has the same type of finish as the Mega Forged Receivers. Mega doesn't do the Mil-Spec RA uppers, but surprisingly they still match decently.
If you can wait, Battle Arms is going to eventually put out an upper, and a Billet Ambi Lower.
-
7 September 2014, 06:59 #52
Actually not. That RA upper was the first one I tried, and it almost fit this lower, but not quite. Had to pound the takedown pin in, so I went with the one above...a BCM blem that I picked up a year or so ago. Probably, when push comes to shove and I actually decide on a barrel, I'll assemble the upper on the RA that I won. The takedown pin will wear in just fine, I'm sure.
-
8 September 2014, 04:25 #53
-
8 September 2014, 15:15 #54
I was considering either a Mega forged or a RA gen2, and now BAD has their own coming out. Not only does BAD make the best selectors their customer service is second to none, Roger and George are the best.
-
8 September 2014, 15:35 #55
Even their business cards rock.
[IMG] image by gostsystems, on Flickr[/IMG]
-
10 September 2014, 11:32 #56Senior Member
- Join Date
- Sep 2014
- Posts
- 556
- Downloads
- 0
- Uploads
- 0
-
10 September 2014, 14:10 #57
-
12 September 2014, 00:27 #58
Not sure which is sexier, this BA lower or the Gen 3 Noveske.
-
12 September 2014, 06:39 #59
-
12 September 2014, 06:45 #60