Refinishing AR15s with Norrells Moly Resin

[Stickman]

Next on the list was to actually get some product to spray. After checking around and reading just about every review I could, I decided that Norrells Moly Resin would be the best finish for me.

http://www.johnnorrellarms.com/


Colors

Prices (including shipping)
$ 25.00 / 8 ounces
$ 50.00 / per quart
$150.00 / gallon

Available Colors



NEW Color ! GLOSSY BLACK
Very Glossy black that looks like an expensive black "blue-job" wet with oil.

BLACK Flat
Black in coloration with a non-reflective dull matte appearance. This a slightly darker shade compared to the above Grayish-Black Moly Resin™. Norrell Manufacturing supplies this Mil-Spec finish to the sub-contractors that manufacture US SOCOM (U.S. Special Operations Command) products for H&K and the U.S. Military such as the sound suppressor for the H&K Mark 23 SOCOM .45 Cal. pistol used by the Navy Seals and Special Forces. It is also used by a number of firearm manufacturers. Our most popular color.

BLACK Semi-Gloss
Black in coloration with a slight gloss that is similar in appearance to the H&K (Heckler & Koch) type finish. Good match to H&K, UZI, and other similar semi-gloss black guns.

GRAYISH-BLACK Flat
Dark gray-black coloration with a flat appearance. This duplicates the appearance of the early original Colt AR-15/M-16 finish. This is the same product that is purchased from us by the U.S. Military to refinish Colt M-16's.

GRAY Flat
A match to older gray military parkerizing including some very early Colt M-16 rifles. Gray flat in coloration with an almost unnoticeable (except under certain lighting conditions) a very slight tint of green. This is a lighter shade of gray than our Greenish-Gray.

GREENISH-GRAY Flat
This is an exact Mil-Spec color match to the U.S. Military parkerizing seen on older military firearms there are turned slightly green due to storage in cosmoline. Base color is grayish-black flat.

GREEN Flat (Olive Drab)
Olive (flat) drab green that is a match to U.S. Military OD green. Also used by a well-known U.S. handgun manufacturer for their .45 cal. pistols and shotguns.

TAN Flat, BROWN Flat, and OFF-WHITE Flat
Basic Camo colors (Tan is new U.S. Military mid-east desert tan 30118 color fed standard 595B)

STAINLESS STEEL
Powdered stainless steel metal mixed with clear phenolic Moly Resin. Gives the appearance of brushed stainless steel when applied over any type of metal. A pleasantly surprising match to real stainless. Used primarily to color match small parts such as scope rings, bases, and other parts, etc. when they are not available in stainless. For best match to brushed stainless, this coating is recommended to be sprayed over a smooth non-abrasive air blasted surface.

CLEAR COAT
Moly Resin phenolic resin with no coloration pigments or additives for lubrication. Can be applied over a cured colored Moly Resin coating or to bare metal.