Opinion on this Ban State 9mm AR build?

[Emilio84]

So I have decided to build a 9mm ar... actually I decided a while ago but that is a whole different story.

This is where I'm at now...

Purchased/On Hand:

KAC RAS
VM Hytech Block
9 preban uzi mags and 3 mag pouches
Ergo Ambi Suregrip
KNS Pins
Gear Sector QD Sling adaptor
Gear Sector Rail Mount QD Sling Adaptor
LPK w/ Geissle SSA
Moe Trigger Guard
Slash 9Q 9mm Buffer
Wolf XP Spring
Badass Modular ambi safety

To Buy:

RRA Upper (from adco)
Adco to Ramp Bolt, Pin Comp, Cut to 16" OAL
Troy rear buis
EGW 9mm Comp
RRA Lower (or any lower that matches)
Bushy Tall Front sight post (to compensate for non f marked FSB on rra upper)
Sully stock w/QD mounts
Gunfighter Charging Handle
Magpul BAD


Opinions? Suggestions?

[Paulo_Santos]

If you don't like the Sully Stock, you can get a regular carbine stock and have ADCO Pin it in place for you.

[Emilio84]

If you don't like the Sully Stock, you can get a regular carbine stock and have ADCO Pin it in place for you.

I actually finally got to feel a sully stock and I'm a fan of them.

[Emilio84]

So I have decided to build a 9mm ar... actually I decided a while ago but that is a whole different story.

This is where I'm at now...

Purchased/On Hand:

KAC RAS
VM Hytech Block
9 preban uzi mags and 3 mag pouches
Ergo Ambi Suregrip
KNS Pins
Gear Sector QD Sling adaptor
Gear Sector Rail Mount QD Sling Adaptor
LPK w/ Geissle SSA
Moe Trigger Guard
Slash 9Q 9mm Buffer
Wolf XP Spring
Badass Modular ambi safety
Sully stock w/QD mounts

To Buy:

RRA Upper (from adco)
Adco to Ramp Bolt, Pin Comp, Cut to 16" OAL
Troy rear buis
EGW 9mm Comp
RRA Lower (or any lower that matches)
Bushy Tall Front sight post (to compensate for non f marked FSB on rra upper)
Gunfighter Charging Handle
Magpul BAD


Opinions? Suggestions?

As an update.. I bought the Sully Stock (sold my ace entry stock/dpms extension/DD burnsed loop setup to fund it), and grabbed an EOTech XPS2-0 on impulse (ridiculous deal).

Also sent my magblock out to get cerakoated as the one I received from Brownells (all three actually) has a terrible finishe and is scratched/scuffed. I'm having it done in graphite black.